34
EN
Network settings
If the device is not operated on a controller it is possible to change the network settings. By default, IP address
assignment is done via a DHCP server. In delivery condition, the network setting is set to “Obtain IP address
automatically”. If an individually set IP address is to be used the menu item “Use the following IP address” must
be selected. The network settings are saved by pressing the button “Send”. For the changes to the network
settings to be applied it is necessary to disconnect the sensor from the power supply for a short time.
WARNING: Only be entering the correct network settings error-free operation of the product can be
ensured. Any incorrect entry of values may result in the device no longer being accessible
in the network.
It must be ensured that supply power is not interrupted while making changes to network
settings. Furthermore, supply power must maintained for at least an additional 5 minutes
after the network settings have been saved to memory.
Display settings
For a functional description of display settings see “7.2. Display” on page 13
Changing the password
An additional window opens where the new password can be entered.
Please note: The password is not permanently stored.
8.5. Measured Value Settings
Filter
For a functional description of the filter see chapter “7.3. Filter” on page 14
Exposure
For a functional description of the exposure see chapter “7.4. Laser” on page 14
Sensor settings reset
A reset restores the factory settings of the display and measured value settings.
