14
EN
6.2.2. Display Intensity
Intensity
Set the display intensity
Min
Normal
Max
Power save
Screensaver
Min:
The intensity of the display is set to a minimum value.
Normal:
The intensity of the display is set to a medium value.
Max:
The intensity of the display is set to a maximum value.
Power save: The display switches off after one minute without a button being
pressed and automatically switches back on when a button is
pressed.
Screensaver: The colors of the display are inverted every minute.
6.3. Filter
The filter (filter size) is the number of measured values over which the Sensor takes an average. The larger the
filter selected, the slower the response time of the Sensor becomes when there is a change in the measured
values. A larger filter improves the reproducibility of the Sensor.
Filter
Number of values for averaging
1
2
5
10
20
50
100
3
Back
7
Run
If 1 is selected, each measured value is output directly without averaging. When-
ever a value greater than 1 is selected, the Sensor takes an average over the
selected number of x measured values.
6.4. Output Rate
The output rate indicates how often the measured value is refreshed per second at the output.
Output Rate
Adjust Output Rate
Normal
Fast
3
Back
7
Run
Normal:
The normal output rate is 100/s.
This means that a new measured value is read out every 10 ms.
Fast :
The fast output rate is 330/s.
This means that a new measured value is read out every 3 ms.
Note: If this mode is activated, the OLED display is switched off
as soon as a PROFINET controller goes online. It’s switch back on
automatically when the controller goes offline again.
