12
If a Fan Panel is required, the following steps are necessary prior
to installing.
1. Open Fan Panel carton on the floor.
2. Turn the Panel so that the outside of the Panel faces upward
(the opening for the fan assembly faces upward) and the Panel
is resting on the carton to protect the Panel finish.
3. Remove fan unit from the carton.
4. Remove fan plate with large hole and remove all three pieces
of cardboard packing (found above and below fan housing and
the motor protector packing).
5. Spin the fan blades to make sure of freedom of movement.
6. Place the fan assembly into the opening of the Fan Panel
by lifting the fan assembly into the upper channel and then
lowering it into the lower channel.
7. Attach the fan to the fan panel with the screws from the
hardware bag.
8. The panel is now ready to be installed as a wall panel in the
module.
assemble the fan panel
iNSTallaTiON
CONTiNuEd
Screws
Fan Connector Cord
Align with holes in
the panel.
assemble the wall vent panel
Pre-assemble the appropriate adapter to the wall vent
panel as follows.
To use in a fan-ventilatated room
, attach a Vent
Diffuser Assembly to the outside of the wall vent
panel. The top of this diffuser extends about two-feet
above the floor. The fan draws ambient air through
the vent and into the room.
1. Place the Vent Diffuser Assembly over the
opening in the wall vent panel outside with the
Vent Diffuser Assembly Open End facing upward.
2, Align the Vent Diffuser Assembly mounting holes
to the wall vent panel pre-drilled screw holes.
3. Attach the Vent Diffuser Assembly to the wall vent
panel with the screws provided.
Screw
Vent Diffuser Open End
Vent Diffuser Assembly
Fan Unit
