
9
PRESSURE WASHER PREPARATION
ATTAChING FOOT ASSEMBLy
(Fig. 1)
PARTS NEEDED: 1 foot, 1 M8 lock nuts.
1. Raise or tilt pressure washer so you can line up foot with the hole
located at the centre of the frame.
2. Align the rubber foot with the hole in the frame where the foot
is to be located. Attach foot by inserting the bolt from the bottom
up and install the acorn nut. Wrench tighten until there is a slight
crush on the frame tube. (Do not over tighten)
Fig. 1
INSTALL hANDLE
(Fig. 2)
Install upper frame (handle) onto the lower frame by sliding the
handle over the two upright tubes on the lower frame and pressing
down firmly until the handle is seated and the two detent pins snap
in place.
Fig. 2
ATTAChING UPPER AND LOWER GUN hOOKS
(Fig. 3)
1. Attach the upper gun hook. Align the upper gun hook with the
holes. Attach using the included nuts and bolts.
2. Attach the lower gun hook. Make sure that the gun hook is
straight and correctly aligned before tightening. Wrench tighten
until the nut is snug. Do not over tighten.
Fig. 3