![background image](http://html1.mh-extra.com/html/wen/rpw31/rpw31_manual_956478019.webp)
19
STORAGE & TRANSPORT PROCEDURES
CAUTION:
Never place any type of storage cover on the pressure washer while it is still hot.
If the pressure washer is being stored for short periods of time (30 to 60 days), add stabilized fuel to the fuel tank
until full. NOTE: Filling the tank reduces the amount of air in the tank and helps reduce deterioration of fuel.
Run the engine for 2 – 3 minutes allowing stabilized fuel mixture to circulate through the carburetor.
STORING ThE PRESSURE WAShER FOR EXTENDED PERIODS:
1. Drain the fuel tank (see “Draining the Fuel Tank” in the “Maintenance” section).
2. Change oil.
3. Do not obstruct any ventilation openings.
4. Keep the pressure washer in a cool dry area.
TRANSPORTING ThE PRESSURE WAShER:
1. Tighten fuel cap. Drain the fuel tank if possible (see “Draining the Fuel Tank” in the “Maintenance” section).
2. Always keep the pressure washer upright. Do not lay it down sideways.
SPRAy NOzzLE
If a pulsing sensation is felt while squeezing the trigger, the spray nozzle may be dirty or clogged and should be
cleaned immediately. To clean the nozzle:
1. Shut off the engine and turn off the water.
2. Remove the nozzle from the spray wand, making sure that the nozzle is pointing away from you and in a safe
direction.
3. Use the nozzle cleaner or a small paper clip to dislodge any foreign materials which are clogging or restricting
the spray tip. Flush debris out of the nozzle by back flushing with a garden hose for 30-60 seconds.
4. Reconnect the nozzle to the spray wand.
5. Turn the water supply back on and start engine.
MAINTENANCE & CARE