![background image](http://html1.mh-extra.com/html/wen/gn875i/gn875i_instruction-manual_956406028.webp)
INSPECTING/CLEANING THE SPARK ARRESTOR
Inspect and clean the spark arrestor every 100 hours of
operation
(refer to Table 4). The spark arrestor is located
outside the muffler, which gets very hot during operation.
Allow the engine to cool completely before servicing the
spark arrestor.
1. Remove the two bolts that secure the spark arrestor to
the muffler. See Fig. 14.
2. Remove the spark arrestor screen.
3. Carefully clean and remove the carbon deposits from the
spark arrestor screen with a wire brush. Replace the spark
arrestor if it is damaged. Replacement spark arrestors can
be purchased from
wenproducts.com.
4. Reinstall the spark arrestor in the muffler and secure it in
place with the screws.
SPARK PLUG MAINTENANCE
Inspect and change the spark plug every 100 hours of operation
(refer to Table 4). The spark plug is important
for proper engine operation. Check the spark plug regularly to maintain proper engine operation. A good spark plug
should be intact, free of deposits, and properly gapped.
1. Gently pull on the spark plug boot to remove it. Be careful not to tear insulation or wire.
2. Use the included spark plug wrench (slide the handle into the hole on the wrench) to u
nscrew the spark plug from
the engine. Remove the spark plug from the engine.
TIP:
There is limited space for the wrench to turn. Use both
rows of holes in the spark plug wrench to gain leverage to loosen the plug.
3. Visually inspect the spark plug. If it is cracked or chipped, or if the electrodes are worn or burned, discard it and
replace with a new spark plug. We recommend replacing it with an
F6RTC
spark plug. These can be purchased from
wenproducts.com.
4. If re-using the spark plug, use a wire brush to clean any dirt from around the spark plug base, then re-gap the
spark plug.
Instructions continue on the next page.
MAINTENANCE
Spark Arrestor
28
Fig. 14