Follow the steps below to properly connect your device(s) to the generator:
1. Before connecting electrical devices, allow the generator to run for a few minutes to stabilize the speed
and voltage output.
2. Select the device with the highest wattage, and make sure it is turned off. Plug the device into the matching
generator outlet and then turn the device on. Allow the engine to stabilize.
3. Repeat step 2 to plug in each additional device. DO NOT attempt to plug in or start multiple devices at the
same time.
Once the total wattage of your electronic device(s) have been calculated, follow the instructions on
the following pages to properly connect the device(s) to the generator.
USING THE GENERATOR
CONNECTING ELECTRICAL DEVICES
CAUTION:
Become familiar with the functions and capacity of each component on the control panel
(page 9) before connecting electrical devices. Do not overload generator or individual panel receptacles.
DO NOT connect 50Hz or 3-phase loads to the generator.
IN CASE OF OVERLOAD
If your generator becomes overloaded from too much drawn wattage, the push-to-reset circuit breaker(s) on
your control panel will activate and cut off the output. When an overload occurs, reduce the load by turning
off and unplugging your electronic device(s), then press the activated circuit breaker to reset your generator.
If the circuit breaker does not reset, wait several minutes and try again. If no power is produced after reset-
ting, restart your generator.
SOME NOTES ABOUT POWER CORDS
Long or thin extension cords can drain the power provided to your electrical devices. Refer to the following
chart in determining the necessary gauge extension cord for each of your devices. Round up to the higher
amperage in the chart to maximize safety.
Fig. 13 - Power Cord Requirement Guide
Device Requirements
Max. Cord Length (ft) by Wire Gauge
Amps
Watts (120V)
Watts (240V)
#8 wire
#10 wire
#12 wire
#14 wire
#16 wire
2.5
300
600
NR
NR
NR
375
250
5
600
1200
NR
NR
300
200
125
7.5
900
1800
NR
350
200
125
100
10
1200
2400
NR
250
150
100
50
15
1800
3600
NR
150
100
65
NR
20
2400
4800
175
125
75
50
NR
25
3000
6000
150
100
60
NR
NR
30
3600
7200
125
65
NR
NR
NR
40
4800
9600
90
NR
NR
NR
NR
23
NR - Not Recommended
