![background image](http://html1.mh-extra.com/html/wen/56310i-rv/56310i-rv_manual_956375016.webp)
16
Oil Dipstick
MAINTENANCE
HIGH ALTITUDE OPERATION ABOVE 3000 FEET
The fuel system on this generator may be affected by operation at high altitudes. Proper operation can be ensured
by installing an altitude kit at altitudes higher than 3000 feet above sea level. At elevations above 8000 feet, the
engine may experience a decrease in performance, even with the proper altitude kit. Operating this generator
without said kit may increase the engine’s emissions and decrease both fuel economy and performance.
The kit should be installed by a qualified mechanic. Refer to the instructions included with your altitude kit for
more information about installation. You can order the kit at wenproducts.com by searching part 56310i-HA36
for 3000 to 6000 feet above sea level or 56310i-HA68 for 6000 to 8000 feet above sea level.
CLEANING THE GENERATOR
Never clean the generator when it is running! Never clean with a bucket of water or a hose. Water can get inside
the working parts of the generator and cause corrosion or a short circuit.
Always try to use the generator in a cool, dry place. If the generator becomes dirty, clean the exterior with a damp
cloth, a soft brush, a vacuum or pressurized air.
CHECKING THE OIL
Check the oil level of the generator according to the Recommended Maintenance Schedule in Fig. 9. The genera-
tor is equipped with an automatic shutoff to protect it from running on low oil. The generator should be checked
before each use for proper oil level. This is a critical step for proper engine starting. To check the oil level:
1. Make sure the generator is on a level surface.
2. Open the side panel that features the small oil fill label on it (same side as recoil starter) using a screwdriver.
Clean around the oil fill. Remove dipstick and wipe the dipstick with a clean rag. Insert the dipstick into the oil fill
opening without screwing in. Remove the dipstick to check the oil mark. Add oil if the oil mark covers less than
one half of the dipstick.
3. Slowly add more oil and repeat step 2 until the oil mark reaches to the top of dipstick (Fig. 10). Do not over fill
the crankcase.
4. Reinstall oil dipstick and side panel.
Fig. 9
WARNING: To prevent serious injury from fire, follow the kit installation proce-
dures in a well-ventilated area away from ignition sources. If the engine is hot from
use, shut the engine off and wait for it to cool before proceeding. Do not smoke near
the generator. Warranty will be void if adjustments are not made for high altitude use.
Summary of Contents for 56310i-RV
Page 36: ...WIRING DIAGRAM 36...
Page 38: ...Thanks for remembering...