![Wen 56235iX Instruction Manual Download Page 25](http://html1.mh-extra.com/html/wen/56235ix/56235ix_instruction-manual_956374025.webp)
MAINTENANCE
WARNING!
Make sure generator is shut off before performing any inspection or maintenance procedures.
CHECKING / ADDING OIL
Check the oil level of the generator according to the Recommended Main-
tenance Schedule in Table 4. The oil level should be checked before each
use or every 8 hours of operation. The oil capacity of the generator engine
is 15 fl. oz. Add oil when the oil level is low.
For proper type and weight of oil refer to “Add / Check Oil” section on
page 12. The generator is equipped with an automatic shutoff to protect
it from running on low oil. To check the oil level:
1. Make sure the generator is on a level surface. Do not tilt the generator
to assist in filling, as oil will flow into engine areas and cause damage.
Keep generator level!
2. Open the oil access cover (Fig. 19 - 1). Remove the dipstick (Fig. 20)
and wipe it with a clean rag.
3. Insert the dipstick into the oil fill opening without screwing in. Remove
the dipstick to check the oil mark. Add oil if the oil mark covers less than
one half of the dipstick.
4. Using a funnel or appropriate dispenser, slowly add more oil. Repeat
step 3 until the oil mark measures between the upper limit mark and half-
way mark of the dipstick. Do not over fill the crankcase.
5. Reinstall dipstick and wipe clean any spill oil with a rag.
DRAINING / CHANGING THE OIL
Change the oil according to the Recommended Maintenance Schedule in Table 4. Change the oil more often if oper-
ating under heavy load or high ambient temperatures. It is also necessary to drain the oil from the crankcase if it has
become contaminated with water or dirt. Changing the oil when the engine is warm allows for complete drainage.
Drain the oil from the generator according to the following steps.
1. Place generator on an elevated platform such as table or desk. Prepare a container underneath the oil fill to catch
the oil as it drains.
2. Open the oil access cover. Remove the dipstick and tilt the generator towards you to allow the oil to drain from
the engine completely.
3. Reinstall the oil dipstick and tighten it securely. Wipe clean any oil spillage and replace the oil access cover.
NOTE:
Do not dispose of used motor oil in the trash or down a drain. Please call a local recycling center or auto
garage to arrange proper oil disposal.
1
Upper Limit
Lower Limit
25
Fig. 19
Fig. 20
Summary of Contents for 56235iX
Page 31: ...WIRING DIAGRAM 31...
Page 36: ...EXPLODED VIEW PARTS LIST CONTROL PANEL 36...
Page 39: ...NOTES 39...