Wen 56202i, Manual

Page: 12 / 32

STARTING THE GENERATOR
To start the generator, perform the following steps:
1. Place the generator outside on a dry, level surface. Allow at least
two feet of clearance on all sides of the generator.
2. Check there is sufficient level of oil in the crankcase. Add oil if
necessary (refer to “Add/Check Oil” on page 9).
3. Check there is sufficient level of gasoline in the fuel tank. Add fuel
if necessary (refer to “Add Gasoline” on page 10).
4. To maximize safety, make sure the generator is properly grounded
(refer to “Ground the Generator” on page 10).
Before starting the generator, make sure you have read and performed the steps in the “Generator Preparation”
section of this manual. If you are unsure about how to perform any of the steps in this manual please call (800) 232-
1195 M-F 8-5 CST for customer service.
STARTING THE GENERATOR
5. Make sure all electrical devices are unplugged from the generator
during ignition. Otherwise it will be difficult for the engine to start.
6. Turn the ECO-MODE switch to “OFF” during starting (Fig. 7).
7. Open the vacuum relief valve on top of fuel cap (Fig. 8) by rotating
it clockwise to the “ON” position. This will allow fuel to flow.
8. Turn the engine switch to the ON position (Fig. 9).
9. Pull out the choke lever to CLOSE the choke valve (Fig. 10).
10. Pull on the recoil starter handle (Fig. 11) slowly until a slight resis-
tance is felt, then pull quickly to start the engine. Return cord gently
into the recoil starter. Never allow the cord to snap back.
11. Repeat step 10 until the engine starts. Note that the engine start
time cannot exceed 15 minutes. If the engine fails to start, allow it to
cool down for one minute before restarting, otherwise it may cause
machine damage.
NOTE: After repeated failed attempts to start the engine, please
consult the troubleshooting guide before attempting again. If problems
persist please call (800) 232-1195 M-F 8-5 CST.
12. After the engine has started, the output indication light (green) on
the control panel will light up.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
12