MAINTENANCE
TROUBLESHOOTING
WARNING
: To avoid accidents, always disconnect the tool from the power supply before cleaning or
performing any maintenance.
1. Clean the tool after every use with a soft cloth or low-pressure compressed air. Do not let water enter the tool.
2. Keep the ventilation openings free from dust and debris to prevent the motor from overheating.
3. Do not use any solvents or cleaning products that could damage the plastic parts. Some of these include but are
not limited to: gasoline, carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that
contain ammonia.
4. Store the tool in the storage case and place it in a clean, dry place away from the reach of children.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This product contains electrical or elec-
tronic components that should be recycled. Please take this product to your local recycling facility for responsible
disposal and to minimize its environmental impact.
14
Problem
Possible Cause
Solution
Motor does not start
Power cord damaged or not
properly plugged in.
Check the power cord, extension cord, power plug and
the power outlet. Make sure the outlet is functional. Do
not use the tool if any cord is damaged.
Defective power switch.
Stop using the tool and contact customer service at (800)
232-1195, M-F 8-5 CST for assistance.
Motor carbon brushes (Part
No. 36703-011) are worn.
Have the carbon brushes checked and replaced by an
experienced technician. You can locate the WEN autho-
rized service center nearest you at http://www.wenprod-
ucts.com/store/service-centers
Defective Motor.
Stop using the tool and contact customer service at (800)
232-1195, M-F 8-5 CST for assistance.
Ineffective Cutting
Cutting blade edges are dull/
worn.
Replace the cutting blade (see page 10).
Blade not suitable for the ma-
terial being cut.
Select the correct cutting blade (see page 10) for you
material.
The blade is not installed
properly.
See instructions for properly installing the blade on
page 10.
NOTE:
Parts that wear down over the course of normal use (like saw blades, carbon brushes, etc.) are not covered
by the two-year warranty. Repairs and replacements should only be performed by an authorized technician. If you
have any questions, please contact our customer service at (800) 232-1195, M-F 8-5 CST or email us at techsup-
[email protected].
Summary of Contents for 36703
Page 16: ...16 EXPLODED VIEW PARTS LIST ...
Page 18: ...THANKS FOR REMEMBERING ...
