Wen 34027, Manual

Page: 11 / 26

INSTALLING SPINDLE LOCK
Remove the spindle lock (Fig. 1 - 1) from the carton and install it onto the headstock with a wrench.
INSTALLING HANDLE
Attach the handle screw (Fig. 2 - 2) through the handle (Fig. 2 - 1) hole onto the handwheel. Secure it
using a screwdriver.
ASSEMBLY & ADJUSTMENTS
11
1
Fig. 1
1
2
Fig. 2
1
2
3
Fig. 3
1
2
Fig. 4
Disengaged
Position
Locked
Position
Fig. 5
WARNING:
Disengage spindle lock before turning the machine on. The lock should be in its
highest available position to prevent it from interfering with the rotation of the spindle (Fig. 5).
INSTALLING TOOL REST
Loosen the locking handle (Fig. 3 - 3) and insert the tool rest (Fig.
3 - 1) into the tool rest base (Fig. 3 - 2). Adjust the height up or
down to the desired position and then tighten the locking handle.
The handle is spring-loaded and can be re-positioned as neces-
sary by pulling outwards, repositioning the lever, and allowing it to
spring back inwards.
INSTALLING THE FACE PLATE
1. Make sure the two set screws (Fig. 4 - 1) in the face plate (Fig.
4 - 2) have been backed out so they do not enter the central bore.
Adjust them, if necessary, with the included hex wrench.
2. Engage the spindle lock (Fig. 5).
3. Mount the face plate by screwing it clockwise as far as it will go
onto the spindle threads. Tighten using the included wrench.
4. Tighten the set screws using the included hex wrench.