Wen 34027, Manual

Page: 6 / 26

1. TOOL PURPOSE. This lathe is designed for turning wood or wood-like products only. Turning other
materials could result in fire, injury, or damage to the workpiece. Using the machine for any other
purpose for which it is not designed may result in serious injuries, machine damage and voiding of the
warranty.
2. MACHINE MOUNTING. For operation safety, the lathe must be securely mounted onto a flat and
stable surface or stand.
3. PERSONAL SAFETY.
• Always wear ANSI Z87.1-approved glasses with side shields, hearing protection and a dust mask.
• DO NOT wear loose clothing or jewelry, as they might get drawn in by the tool. Tie back long hair.
• DO NOT wear gloves while operating this machine.
4. ELECTRIC CORDS. Keep cords away from heat, oil, sharp edges, and moving parts of the tool. Have
an electrician replace or repair damaged or worn cords immediately.
5. TOOL & ACCESSORIES INSPECTION. Before operation, check the tool and accessories for any dam-
age or missing parts. Do not use the tool if any part is missing or damaged. Make sure all adjustments
are correct and all connections are tight. Keep all guards in place.
6. LATHE ACCESSORIES.
• Do not use tools, chisels, or any accessories that are damaged,or worn.
• Make sure all tools, chisels, and accessories are sharp enough for the task at hand before using them.
• Always use the right tool at the correct speed and feed rate.
• Always turn off and unplug the unit before doing any cleaning or maintenance. Use a brush or com-
pressed air to remove chips or debris. Never use your hands to remove excess material and debris.
7. WORKPIECE REQUIREMENTS. Check the workpiece carefully for splits, knots, nails, or other ob-
structions. These types of blemishes may cause a safety risk during turning.
8. ADJUST the tool rest to the proper height and position for the task at hand. Rotate the workpiece by
hand to check clearance with the tool rest before turning the machine on.
9. SELECT THE APPROPRIATE SPEED for the task at hand. Start at a low speed and allow the lathe to
ramp up to the operating speed before engaging any chisels, tools or other carving accessories.
10. NEVER APPLY COOLANTS OR WATER to a spinning workpiece. Never stop a rotating workpiece
with your hand.
11. If gluing a workpiece, always use a high quality glue that meets the needs of the particular work-
piece.
SPECIFIC RULES FOR THE WOOD LATHE
WARNING:
Do not let comfort or familiarity with the product replace strict adherence to
product safety rules. Failure to follow the safety instructions may result in serious personal injury.
6