16
TURNING ON / OFF AND ADJUSTING THE SPEED
The speed adjustment knob on the front of the control panel (Fig. 12
- 1) turns the machine ON and OFF and adjusts the speed within the
unit’s capable speed range.
1. Always make sure the speed adjustment knob is in the OFF setting
before plugging in the machine
2. Release the E-Stop switch (Fig. 12 - 2) by rotating the switch
clockwise, allowing the button to spring outward.
3. Select a direction for the spindle to turn (Fig. 12 - 3).
4. Turn ON the machine by rotating the knob clockwise. A “click” will
be heard as the motor is turned ON, but the spindle will not rotate
ASSEMBLY & ADJUSTMENTS
6. Give the machine an ample amount of time to ramp up to the operating speed before lowering the cutting tool into
the workpiece. The current speed will show on the LED speed display (Fig. 12 - 4).
7. To turn OFF the machine, SLOWLY rotate the speed adjustment knob counterclockwise until a “click” is heard
and the knob points to the 0 position, then turn the direction selector knob to the OFF position. For emergency stop,
press down the E-Stop button (Fig. 12 - 2). Make sure to always return the speed adjustment knob and the direction
selector knob to the OFF position so that you don’t risk accidentally starting the machine when the Emergency stop
button is released.
CAUTION!
It is crucial to adjust the speed slowly or you may risk damaging the gears.
OPERATION
WARNING!
To prevent serious injury, make sure all the warnings and instructions have been read and
understood before operating this tool.
WARNING!
Always wear ANSI Z87.1-approved eye protection and a face shield/dust mask when using this
machine. Chips and dust fly at high speed during operation, and may cause injuries if they hit you.
1
2
3
4
Fig. 12
until the knob is turned further clockwise.
5. SLOWLY rotate the knob further and allow the speed to increase.
