11
ASSEMBLY & ADJUSTMENTS
CLEANING THE SURFACES
Your tool comes protected with a layer of heavy-duty anti-rust coat-
ing. Remove the protective coating from surfaces using a soft cloth,
moistened with kerosene (do not use cellulose-based solvents such
as paint thinner or lacquer thinner, as these will damage the painted
surfaces). Apply a light layer of good-quality machine oil onto the
machine’s surfaces to protect from rust and corrosion.
MOUNTING TO A BENCHTOP
For safe operation, the machine must be securely mounted onto a
flat, secure workbench. Place the workbench away from direct sun-
light, high moisture, or dust.
Position the machine on the benchtop and leave enough space
around the machine for table travel. For unrestricted handwheel op-
eration, make sure the cross feed and longitudinal feed handwheels
extend out beyond the edge of the benchtop. Square the machine to
the benchtop using a precision level.
Drill four 10 mm-diameter mounting holes on the benchtop (same
size as the machine’s mounting hole). Mount the machine using four
M10 hex bolts, eight flat washers, four lock washers, and four hex
nuts (mounting hardware not included) (Fig. 2).
TIP:
Your milling machine is compatible with the WEN 6588 Multipur-
pose Planer Stand, available at
wenproducts.com
. Forget measuring
and drilling holes on your workbench, simply mount your machine
onto the mobile stand with pre-drilled holes, and transport your ma-
chine around the workshop with ease.
WARNING!
To prevent injury from accidental operation, make sure the tool is switched OFF and unplugged
from the power source before assembling the tool or making any adjustments.
Fig. 2
Fig. 3
Machine Base
Workbench
Workbench
1
1
INSTALLING THE HANDWHEELS
The two handwheels have been initially installed in the reversed direction for shipping purposes. Unscrew the hand-
wheels and install them in the correct orientation (Fig. 3 - 1)
PREPARING VISES TO SECURE WORKPIECE
A vise (not included) is a crucial attachment to hold your workpiece in place when using the milling machine. You
can purchase a milling vise or quick vise that is suitable for your workpiece and milling operation. The WEN 33124A
3.5 inch Quick Release Vise is perfect for holding your workpieces.
You may also use clamping kits to hold the workpieces to the machine’s worktable. Follow the instructions with your
accessory for proper installation and operation.
Your machine can work as both a milling and drilling machine, depending on the type of cutter that is installed. Refer
to the introduction below for some common cutter holders and cutting tools that you can install onto your machine.
