![background image](http://html1.mh-extra.com/html/wen/23006/23006_manual_956414005.webp)
5
ROTARY TOOL SAFETY RULES
ROTARY TOOL ACCESSORIES
1. The rotary tool accessory must have a rated speed higher than 25,000 RPM (the maximum operating
speed of your rotary tool), otherwise there is a risk of injury.
2. The spindle diameter of the accessory bit must match the size of the collet. The included collet size is
1/8 inch (3.2 mm); collets of other sizes may be purchased separately depending on the spindle diameter of
the accessory.
3. Inspect the accessories for any cracks, excess wear, or bent shanks. Do not use damaged accessories.
ROTARY TOOL OPERATION
1. Do not force the tool to do a job for which it was not designed. Use the correct power tool and accesso-
ries and follow the instructions for your application to prevent hazardous situations.
2. Before operation, check the tool for any damage or missing parts. Check for misalignment of moving
parts, jamming, breakage, improper mounting, or any other conditions that may affect the tool’s operation.
Do not use the tool if the power switch is faulty, the plug or cable is damaged, or the tool produces sparks
or smoke. Any part that is damaged should be properly repaired or replaced before use
3. Avoid accidental start-ups. Make sure the tool is OFF before installing batteries, making adjustments, pick-
ing up or carrying the tool.
4. Remove adjustment tools. Always make sure all adjustment tools or wrenches are removed from the tool
before turning on the power tool.
5. Set the suitable speed for your operation, workpiece and accessory. Use slow speeds for some plastics
and precious metals to prevent damaging the material.
6. Before turning on the rotary tool, ensure that it is completely clear of the workpiece. Let the tool reach
full speed before making contact with the workpiece.
7. When operating the rotary tool:
• Do not apply excessive pressure to the tool or attempt to make an excessive depth of cut. Overstressing
the tool may cause kickback and damage the tool and accessories.
• Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory.
• Never touch any moving parts of the tool by hand.
• Never press in the spindle lock button when the rotary tool is running.
8. Never leave a running tool unattended. Do not leave the tool until it has come to a complete stop.
9. Clear the tool from the workpiece before switching off the tool. Wait for the rotary bit to come to a com-
plete stop before setting the tool down. Do not touch the accessory attachment immediately after operation,
as it may be very hot. Allow time for the accessory to cool and calm down before removing it.
Summary of Contents for 23006
Page 14: ...EXPLODED VIEW PARTS LIST 14 ...