10
OPERATION
WARNING:
Do not let comfort or familiarity with the product replace strict adherence to
product safety rules. Do not plug in or turn on the tool until it is fully assembled according
to the instructions. Failure to follow the safety instructions may result in serious personal
injury.
WARNING:
Thoroughly read and understand all instructions before using this product.
Save this manual.
TURNING ON/OFF
It is recommended that you practice on scrap material be-
fore you start your project.
1. Before using the engraver you must install the carbide tip
(see instructions on p. 9).
2. Connect the engraver plug to the power supply. While
firmly holding the engraver, toggle the power switch to the
ON position (Fig. 2).
3. Hold the engraver at an angle, like you would hold a pen.
Fig. 2
ON
Fig. 3
Thick/Deep
Fine/Shallow
ON
OFF
Do not press down hard while engraving; use light pressure while guiding the point over the
work to be completed.
NOTE:
Use one of the included stencils for more precise engraving.
4. Toggle the power switch to the OFF position (Fig. 2) to turn the engraver off. Disconnect
the engraver plug from the power supply.
NOTE:
Always allow the engraver to completely cool down after operation and before storage.
ADJUSTING THE DEPTH
The depth adjustment knob (Fig. 3) controls the stroke
length and therefore the depth of engraving.
For a fine/shallow mark:
1. Turn the depth adjustment knob counterclockwise to po-
sition ‘1’.
For a thick/deep mark:
1. Turn the stroke adjustment dial clockwise to position ‘5’.
NOTE:
The positions 1-5 get deeper as you turn the depth
adjustment knob clockwise, 1 being the most shallow, and
5 being the most deep.
