16
Owner’s Manual
WMC-2500
Figure 22 – Removing Filters
Figure 23 – Removal of dust
Maintenance
FILTER CLEANING (Without
fl
ange)
There are 2
fi
lters in the unit. The evaporator
fi
lter is located at the front of the unit. The con-
denser
fi
lter is located at the rear of the unit.
1. Open the front grill.
2. Slide
fi
lter up and use vacuum cleaner to remove the dust from the
fi
lter.
3. If the
fi
lter is heavily covered with dust and dirt, warm water and mild soap or neutral deter-
gent may be used to wash the
fi
lter. Do not use any other chemicals to clean
fi
lter, as they will
likely damage the
fi
lter.
4. Dry the
fi
lter in a shaded area before replacing it. Do not operate the unit without the
fi
lter
installed and the
fi
lter frill in the closed posi on.
5. Replace the clean
fi
lter and close the
fi
lter grill.
6. To clean the condenser
fi
lter, li up on the rear
fi
lter from the middle bar slightly and then
angle the
fi
lter outwards from the bo om and remove.
7. Use the sale cleaning procedure as above (3~5)
8. To replace the condenser
fi
lter, place the top of the
fi
lter in the guide and slide the
fi
lter up
un l the bo om of the
fi
lter clears the frame.
Then push the bo om of
fi
lter into the guide and let
fi
lter into guide and let
fi
lter fall inside the
guide.
NOTE :
For e
ff
ec ve cooling clean the
fi
lter at least every 2 weeks.
– Remove dust from the
fi
lter using a vacuum
cleaner hose a achment.
– If required wash the
fi
lter in lukewarm water
with a mild detergent. Leave to dry in a shaded
area before reinstalling.
– Pull the
fi
lter frame forward to remove the front
fi
lter.
– Slide
fi
lter up and use a vacuum cleaner to remove
the dust from the
fi
lter.
– Li up on the rear
fi
lter from the middle bar slightly
and then angle the
fi
lter outwards from the bo om
and remove.
