WELLTECH ePBX-100A-128, User Manual

Page: 18 / 124

18
Note:
•
Normally, SIP From URI will contain the Extension’s calling ID and
ePBX-100A-128’s IP address, but some ITSP may reject this call due to some
security issue. You can modify the Calling ID and IP/ Domain in the fields of
[External Server Address] and [Outbound Caller ID] when the call is going via the
ePBX-100A-128 to the Destination (Trunk) to avoid such security issue.
•
If you set a Welltech FXO gateway as the Trunk, you can just use the default
Trunk 888 and 889 as the FXO’s register number.
•
For the FXO gateway, you may just only configure Trunk Number, Password,
Host, DialPlan, Keypad, NAT Traversal and RTP Mode.
•
If you set the ITSP as the Trunk, you may need to set the following configure: Port,
External Server Address and Outbound Caller ID.
•
For more information, please refer to the user manual
CH5.1Appendix-Application between Welltech CPE device and
ePBX-100A-128
„
Comment: You can input a 10 byte note for each Trunk here.
„
Hot-Key Tran: Enable this feature will permits the calling party or called party to
transfer a call by pressing the *0 (For Blind Transfer) or *9 (For consultant Transfer)
key if the call is Between Extension and Trunk. Default is disabled.
Note:
•
If you enable this feature in Trunk page, we suggest you also enable Hot-Key
Tran of IP PBX page.
•
Please note that if this option is used, the RTP Mode will always be Routed Mode,
as ePBX-100A-128 needs to monitor the call to detect when the caller presses
the *0 or *9 key.
„
Music RBT: Provides music to the calling party until the call is answered
Press Apply to save configuration, or press Cancel to quit configuration.