WELLTEC DHN20, Manual

Page: 38 / 60

www . W elltec . pro 36
Press the
„
POWER
”
button to turn on / off the device. The default mode
after the first start is continuous operation ( CO symbol on the display). In
this mode, the dehumidifier collects moisture until it reaches the set level.
The current humidity or temperature level is shown on the device display.
To switch the display mode, press and hold the
„
UP
”
and
„
DOWN
”
buttons
at the same time .
Use the
„
UP
”
and
„
DOWN
”
buttons to set the desired humidity level. The
desired level can be set between 30 and 90% in 5% increments.
The operating mode of the device is changed by pressing the
„
UP
”
or
„
DOWN
”
button several times. Possible settings are continuous operation
mode (
CO
) or comfort mode (
AU
).
This is the default device operation mode. After setting the humidity level
using the
„
UP
”
and
„
DOWN
”
buttons, the dehumidifier will work until the
humidity level is 2% lower than the set level. When it reaches it, the
compressor will turn off and the
„
OK
”
LED will light up on the panel.
If the humidity level rises above 3% from the set value, the dehumidifier will
start by running the compressor and the fan.