Wella Visionair M50, Operating Instructions Manual

Page: 43 / 178

45
ENGLISH
6 Errors and possible rectification
You can perform the rectification measures listed below yourself, making sure
you follow the safety instructions.
Should further errors or malfunctions occur or the rectification measures listed
fail to eliminate the error, write down the error messages displayed and contact
the Wella Customer Service Centre.
For your own safety, do not try to correct other problems yourself!
The appliance switches off during operation:
Overheat protection 1. The overheat protection
switch has switched off
the appliance.
➥
Switch off appliance at the ON/OFF switch a .
Allow the appliance to cool down.
Remove the
power plug e
.
➥
Check the air filter in filter cover b as
described in “Section 5.3” page 44 and change, if
necessary.
2. The overheat protection
switch has switched off
the appliance again.
➥
Switch off appliance at the ON/OFF switch a .
Remove the power plug e .
Attach a FAULTY sign to the appliance.
Contact Customer Service.
The appliance switches off after 60 minutes of continuous operation:
Safety off 1. No error. The safety off
has switched off the
appliance.
➥
If a drying time of more than 60 minutes is
needed, the appliance must be restarted after
the initial 60 minutes are up by turning the
control button h and inputting a new time.
The appliance has insufficient drying power:
Airflow setting 1. Airflow is set to level I
➥
Set airflow to level II as described in “Section
4.5.3” page 41.
Airflow grille and air filter 2. The airflow grille
4
or
air filter in filter cover b
are soiled.
➥
Switch off appliance at the ON/OFF switch
a
.
Remove the power plug e .
➥
Clean the airflow grille
4
as described in
“Section 5.2” page 43.
➥
Check the
air filter
in
filter cover b
as
described in “Section 5.3” page 44 and change, if
necessary.
Excess heat to neck when drying short hair or with small curlers:
Long-hair drying Long-hair drying function is
activated
➥
Deactivate long-hair drying function as
described in “Section 4.6” page 42.
Error message:
Error code E2 Electronics defective
➥
Contact Wella Customer Service.
Error code E4 Temperature sensor faulty
➥
Contact Wella Customer Service.
Error code E5 Short circuit in temperature
sensor
➥
Contact Wella Customer Service.
For all error codes Switch off appliance at ON/OFF switch a . Unplug the power plug e .
Attach a FAULTY sign to the appliance.