Wella Visionair M50, Operating Instructions Manual

Page: 39 / 178

41
ENGLISH
4 Operation
Figure 5
4.5 Changing appliance settings
You can change all the settings on the Visionair by turning and/or pressing the
control button h
. You can see your settings on the
control panel 9
.
Turning
the
control button h
changes the appliance setting values.
By pressing the control button
h
once at a time, the appliance settings for
temperature , airflow and drying time are selected in that order, starting with the
drying time setting (loop).
After 10 seconds in the appliance setting temperature and airflow , the display
automatically goes back to the drying time setting .
4.5.1 Setting the drying time
1. Turn control button h and set the desired drying time k .
➥
The appliance starts.
➥
The two pilot lamps j light up.
Extending the drying time
• You can change the drying time at any time during the treatment
by turning the control button h .
• The total treatment time is limited to 60 minutes for safety reasons.
If a drying time of more than 60 minutes is needed, the appliance
must be restarted with a time input by turning the
control button
h
.
• Then the drying time can be set to max. 60 minutes once again.
4.5.2 Setting the temperature
1. Press the control button h repeatedly until the appliance setting
temperature is selected.
➥
The temperature symbol i flashes.
➥
The default, recommended setting is temperature level 8 .
2. Turn the control button h and set the desired temperature level m .
4.5.3 Setting the airflow
1. Press the
control button h
repeatedly until the appliance setting
airflow
is
selected.
➥
The airflow symbols
l
flash.
➥
The default, recommended setting is airflow level II .
2. Turn the control button h and set the airflow to level I or level II .
• The appliance settings temperature and airflow can be reset at any time:
1. Press the control button h repeatedly until you reach the desired appliance
setting e.g. temperature .
2. Turn the control button h and set the desired temperature level m .
NOTE