The thickness can be changed of three positions. Connect it using 2 pcs M8x12 Bolts (A), and
tighten using the hex key (E).
Tighten the “c’-Clamp to the desktop by twisting the plastic knob, see Figure 2.
Option A: Base Install
Self Drilled Hole Installation
Position the Pole(a) on the mounting surface and mark the center hole. Drill a 3/8” (10mm)
diameter hole at the marked position through the mounting surface.
1. Remove the 3pcs M5X20 bolts at the bottom of the pole(a) with hex key, see Figure1A.
2. Install the Base Plate (f) to the Pole(a) using 3 pcs M5x20 Bolts, and tighten using the hex key
(E), see Figure 5.
3. Use screwdriver counter-clockwise release the screw, and counter-clockwise release the plastic
knob. see Figure 5A.
4. Position the Pole (a) on the mounting surface and secure using the Support Plate (B), see
Figure 6.
