WELDMAN
POWER PULSE DC TIG 200 HF / LIFT
5
7) To the input of the shielding gas (plug coupling of the back panel) to connect the
7) To the input of the shielding gas (plug coupling of the back panel) to connect the
feeding gas from the cylinder via the clamp and the coupling (only TIG)
8) The other end of the mass must be fitted to the output reducer gas to the gas cylinder (only
8) The other end of the mass must be fitted to the output reducer gas to the gas cylinder (only
TIG)
9) Prepare the protective clothing (apron, boots and hood / welding helmet)
9) Prepare the protective clothing (apron, boots and hood / welding helmet)
ATTENTION!
Correct connection to the sockets method of MMA is dependent on the properties of the electrodes and the information on the pack by the manufacturer.
VI. WELDING
VI. WELDING
When you turn the welder off the main switch on the rear panel of the display symbol P04, meaning the performance test of the PCB, and then illuminates
the LED (4) indicating the welding current, and displays its current value. The value of the welding current can be adjusted by turning the knob SELECT.
After changing the value 3 seconds after the changed value is stored into the cache welder. Before starting the welding parameters must be set other work
on the front panel.
TIG welding and TIG PULS
Depending on the material being welded and individual operator preferences, set the operating parameters. The mode switch to select the mode flare holder
(2-stroke or 4-stroke) and arc ignition way (contact - contactless HF - LIFT).
To access the settings menu of operating parameters, press the multifunction knob - further LED lights welding current (4), then rotate the knob by going to the
parameter to be changed (LED lights continuously). Presses the knob (flashing), rotating knob changing the value of a parameter. After setting the parameter:
- after 3 seconds value is stored into memory, and returns to positions: welding current (4)
- presses the knob (saving value) and turning the knob to move the next parameter. Flashing LED indicates the ability to change the parameter, continuous
light - save the changes. The parameters that are possible to control depend on the selected switch (7) operating mode:
Lp.
Description
1
GAS PRE - Time flow of gas prior to arc ignition (control 0.1-1 seconds)
2
current start - only a 4-stroke (5-200 A)
3
welding current rise time (0-10 sec.)
4
welding current (5-200 A)
5
current pulse basis -
only in TIG PULS (
5-200 A)
current pulse basis -
only in TIG PULS (
5-200 A)
current pulse basis -
only in TIG PULS (
5-200 A)
6
pulse rate -
only in PULSE (
0.5-100 Hz)
pulse rate -
only in PULSE (
0.5-100 Hz)
pulse rate -
only in PULSE (
0.5-100 Hz)
7
pulse width -
only in PULSE (
5-100%)
pulse width -
only in PULSE (
5-100%)
pulse width -
only in PULSE (
5-100%)
8
downslope time (0-10 sec.)
9
current end - only a 4-stroke (5-200 A)
10
POST function GAS - Time flow of gas after the expiration of the arc (0.1-10 s).
11
enable / disable function TIG PULS
