Page of 8
4
ASSEMBLY
Pivot Clamp Support and Measuring Rod
Insert the pivot clamp support (adjustable vertically) into the saw horse table with the measuring rod
holder (adjustable horizontally), using the bolt and washer supplied.The vertical adjustment for the
pivot clamp support is to accommodate different sized chain bars – the larger and longer the bar, the
higher the pivot clamp should be placed. Adjust so that the tip of the chain bar extends beyond the
table, so that it is cutting completely through the log. The measuring rod can be adjusted horizontally
to allow each log to be cut to the desired length.
Pivot Clamp
Insert the male rod on the pivot clamp into the female cylinder on the pivot support clamp and secure
with the R-clip.
Carefully lower the chain saw bar into position between the two solid blocks in the pivot
clamp and ensure a 0.9in. (2cm) gap between the body of the chain saw and clamp.
Make sure
that the bar is approximately 90° to the clamp and well clear of the chain before tightening the bolt.
Once tightened, test the arc of travel to make sure that the chain bar does not touch any part of the
saw bench.
