2
Your Wel-Bilt™ Palm Sander has been designed for stripping paint, smoothing rough wood surfaces
and fine-finishing woodcraft projects. The Wel-Bilt™ Palm Sander is intended for DIY use only.
Warning!
When using power tools, basic safety precautions including the following should always
be followed to reduce the risk of fire, electric shock, personal injury and material damage.
Read the whole manual carefully and make sure you know how to switch the tool off in an emergency
before operating.
The electric motor has been designed for one voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
This tool is double insulated; therefore, no ground wire is required. If the supply cord is
damaged, it must be replaced by the manufacturer or an authorized service center immediately
in order to avoid a hazard.
Using an Extension Cord
Always use an approved extension cord suitable for this tool. Before use, inspect the extension cord for
signs of damage, wear and ageing. Replace the extension cord if damaged or defective.
When using an extension cord on a reel, always unwind the cord completely. Use of an extension cord
not suitable for the tool, or is damaged or defective, may result in a risk of fire or electric shock.
1.
Verify that the power supply in your area is compatible with the voltage listed on the tool's label.
2.
Check the tool, cord and plug for damage before each use.
3.
Make sure the tool is turned off before plugging it in.
4.
Always start the tool before setting it against the piece you are working on.
5.
Watch for, and avoid, potential electrocution hazards. Avoid bodily contact with grounded objects
such as metal pipes, radiators, cooking ranges, refrigerators and so forth when using the tool. Never
work on any item that is connected to a live electrical circuit. Always disconnect electrical items
before working on them.
6.
Extreme temperature variations may cause condensation, which can increase the hazard of
electrocution and/or internal corrosion. Allow the tool to adjust to the temperature of the work area
for several minutes before each use.
7.
Secure all items you are working on. Use clamps, vices or other securing devices as needed.
8.
Never wear jewelry or loose clothing that can become entangled in moving parts. Tie or otherwise
secure long hair away from the tool and work area.
9.
Use safety apparel and equipment. Use ANSI-approved safety goggles or safety glasses with side
shields that comply with current national standards, or when needed a face shield. Use an NIOSH-
approved respirator or dust mask when necessary. This applies to all persons in the work area. Wear
non-skid safety shoes, a hard hat, gloves and earplugs when appropriate.
INTRODUCTION
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
GENERAL SAFETY RULES
