4
1 General information
These installation and operating instructions
•
are an integral part of the equipment and must be kept
permanently on site.
•
are to be used by qualified personnel only.
•
contain the relevant information for the safe assembly,
commissioning and servicing of the equipment
•
are for the attention of all personnel working with the
equipment.
Explanation of notes and symbols
This symbol is used to mark instructions,
which, if not followed, could result in death or
serious injury.
This symbol is used to mark instructions,
which, if not followed, could result in life
threatening electric shock.
This symbol is used to mark instructions,
which, if not followed, could result in damage
to, or the destruction of the equipment and
environmental damage.
☞
This symbol is used to mark procedures,
which you should follow.
1.
Procedures with more than one step are
2.
numbered.
3.
❑
This symbol is used when you are required to
carry out a test.
•
This symbol is used to list points.
Abbreviations
Tab.
Table
Ch.
Chapter
Hand-over and operating instructions
The contractor is responsible for passing the operating
instructions to the plant operator prior to hand-over. He
should also inform the plant operator that these
instructions should be kept with the heating appliance. The
address and telephone number of the nearest service
centre should be entered on the reverse of the operating
instructions. The plant operator must note that an agent of
the contractor or other suitably qualified person must
inspect the plant at least once a year. To ensure regular
inspections, -weishaupt- recommends a service contract.
The contractor should instruct the plant operator in the use
of the equipment prior to hand-over and inform him as and
when necessary of any further inspections that are
required before the plant can be used.
Guarantee and liability
Weishaupt will not accept liability or meet any guarantee
claims for personal injury or damage to property arising as
a result of one or more of the causes below:
•
Failure to use the equipment as intended
•
Improper assembly, commissioning, operating or
servicing of the equipment.
•
Operating the appliance with defective safety
equipment, or with non-recommended or non-
functioning safety and protection devices
•
Failure to follow the information in the Installation and
Operating Instructions
•
Alterations made to the construction of the equipment
by the plant operator
•
Fitting additional components not tested or approved
for use with the equipment.
•
Alterations made to the equipment by the plant
operator (e.g. motor ratio - rating and speed)
•
Alterations made to the combustion chamber, which
hinders constructive, predetermined flame formation
•
Inadequate monitoring of parts liable to wear and tear
•
Improperly executed repairs
•
Acts of God
•
Damage caused by continued use despite the
occurrence of a fault
•
Use of incorrect fuel
•
Obstruction or damage of the supply lines
•
Use of non-original -weishaupt- spare parts
DANGER
ATTENTION
DANGER
