Installation and operating instructions
Fresh water station WHI freshaqua 22
5 Installation
83514302 ▪ 1/2017-08 ▪ Ext. PAW
18-32
5.1
Assembly
WARNING
Risk to life and limb due to electric shock!
Prior to performing electrical work on the controller,
de-energise the system.
For more information, see enclosed installation and
operation instructions of the station controller.
Connect the fresh water station to the power supply
system (230 V, 50 Hz) only after completing all
installation tasks, filling and flushing. This avoids an
unintentional start of the motors.
NOTICE
Material damage!
In order to avoid damaging the system, the installation
site must be dry, structurally safe and frost-free.
Furthermore, access to the closed-loop control and
safety equipment must be guaranteed at all times
during operation!
If tapping points are connected to the same network
as the fresh water station, in which pressure surges are
possible (e.g., flushing valves, washing machines or
dishwashers), we recommend the installation of water
hammer dampers near the device causing the
pressure surges.
1.
Place the installation site of the fresh water station near the buffer
tank. With long connecting lines, the transfer capacity is reduced due
to higher pressure drops.
2.
Transfer the dimensions for the drill holes onto the wall. A suitable
drilling pattern can be found on the carrying aid below the fresh water
station.
3.
Drill the holes and insert the enclosed wall plugs. Make sure that the
ground has sufficient load-carrying capacity.
4.
Screw the screw into the plug until it protrudes about 40 mm from the
wall.
5.
Pull off the front shell.
6.
Hang the fresh water station on the screws.
Tighten the screws so that the insulation on the sides rest against the
wall.
