1x
3x
2x
green
red
3 / 4
Re-key the lock (if needed).
Install the battery cover.
Confirm that the code(s) added in previous step can unlock the door.
A
B
One green flash with one beep*
Three red flashes with three beeps*
Two beeps*
or
or
IMPORTANT:
Remove battery
pack before
re-keying.
Make sure the door is open. Press
the Program button the number of
times that corresponds to the user
code position being programmed.
Locking the Door
Unlocking the Door
Enter user code. A total of 30 user
codes may be programmed.
Press Lock button once.
A
B
C
What lights and sounds does the lock produce?
D
Each user code must
be a unique code
between 4 and 8 digits,
depending on your
smart home system.
Example: If
programming
the third code,
press the button
three times.
Programming was successful.
Programming was unsuccessful.
Make sure the user code is not a duplicate and that it is
between 4 and 8 digits during your next attempt.
Programming time out.
Make sure not to pause for more than 5
seconds during programming.
Press Lock button once.
Enter user code.
It is recommended that you add and
delete all user codes through your smart
home control system. If your system
does not allow this, codes may be added
directly to the lock as shown here.
Programming Timeout
If no button is pressed for 5 seconds, the
system will time out and you will need to
restart the procedure.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See “Switches and Status LED Colours” on page 4.
Mastercode
For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode, download the Programming
and Troubleshooting Guide on the SmartCode 5 Lever page at www.weiserlock.com.
K
K
M
H
V
(2x)
Tip: You can press the
Lock button before
entering your user
code to light up the
keypad at night.
actual
size
V
a
a
b
b
c
Re-key the lock to work with your
existing key. See the supplied
SmartKey Re-key Instructions
for more information.
Reinstall
battery
pack.
8
9
10
Add user codes (30 max)
Re-key the lock (if needed) and install the battery cover
Test the lock (review normal operation)
7
Add the lock to your smart home system
button “A”
Please allow time for the controller to add the lock.
Initiate the process to add
the lock to your system at
your smart home controller.
Refer to your smart home
system instructions for
more information.
When prompted by your smart home system to add the
lock, press button “A” on the lock interior one time. The
red LED will illuminate when the lock enters Add Mode.
If successful, re-name the lock in your system
(if applicable).
If unsuccessful, follow your system's instructions to
remove the lock from the controller and any other
network, then press button “A” on the lock one time.
Perform steps 7A-7C again.
If still unsuccessful, consult the Programming and
Troubleshooting Guide on the SmartCode 5 Lever
page at www.weiserlock.com.
A
B
C
D