- 11 -
(5)
“Inductance” regulation knob
Altering welding stability, penetration and spatter volume. Recommend value is 5-7.
(6)
“4-step /2-step” mode switch
Switch to “2-step”, perform welding when push torch switch, stop welding when
release the switch. This mode is suitable for short weld. To “4-step”, after
successfully starting arc by push torch switch, then you can perform welding by
release the switch, when you push torch switch again, torch will turn into
crater-filling situation which was preset by stop- arc knobs on the front panel.
The
welder will stop welding when release the switch. This mode is suitable for welding
long weld.
(7)
Gas Test button
Press this button, the gas flow will keep for 30s; while it will stop the gas if press it
during the 30s.
(8)
Wire Test button
This button function is the same as torch switch. Press this button, the wire will
feeding; release the button, the wire feeding will stopped.
(9)
Negative terminal (-)
Connect to the work lead by the ground cable.
(10) Wire feeder’s control cable socket
Connect to wire feeder’s control cable
(11) Positive terminal (+)
Connect to wire feeder’s welding cable
