© 2021 W einzierl Engineering GmbH
Seite 6/16
2.3 Manual control TP
Briefly pressing button A
❻
activates the manual operation for TP mode.
Briefly pressing again the A button
❻
enables/disables the Routing of the group telegrams. This is
indicated by the LEDs 1 and 2
❺
.
Briefly pressing the B button
❼
enables/disables the Routing of the individual addressed telegrams
and the broadcast telegrams. This is indicated by LEDs 3 and 4
❺
.
A long press on button A
❻
or button B
❼
terminates manual operation.
Manual control can be locked in the ETS database.
2.4 Manual control RF
Briefly pressing the B button
❼
activates the handset for RF mode.
Briefly pressing the A button
❻
enables/disables the Routing of the group telegrams. This is
indicated by the LEDs 5 and 6
❺
.
Briefly pressing the B button
❼
enables/disables the Routing of the individual addressed telegrams,
the (system-) broadcast telegrams. This is indicated by the LEDs 7 and 8
❺
.
A long press on button A
❻
or button B
❼
terminates manual operation.
Manual control can be locked in the ETS database.
3
Factory setting
The following configuration is preset at the factory:
Physical address of the device
15.15.0
Routing TP->RF:
Physically addressed telegrams:
Filter
Group telegrams:
Filter
Routing RF->TP:
Physically addressed telegrams:
Filter
Group telegrams:
Filter
3.1 Reset to factory settings
It is possible to reset the device to these factory settings.
Disconnect the KNX bus connection
❸
from the device
KNX programming button
❶
press and hold down
Restore KNX bus connection
❸
to the device
Keep the programming button
❶
pressed for at least 6 seconds
A short flashing of all LEDs
❷
,
❹
and
❺
indicates the successful reset to factory settings.