3.
Click left and right arrow buttons to move the camera. Stop moving the camera
until the cross in camera center is at the hole center.
4.
Click
Record Pos 2
. The system will automatically calculate the offsets in both
X-axis and Y-axis.
Picking Template
In shoot-cut mode, marks (also called marking point or template) are used to figure
out the tool path.
Requirements of the target marking points:
•
Clear enough
•
Being unique
Steps
1.
Turn to
Manual
mode, and click
Vision
→
CCD
to switch to
CCD
interface.
2.
Click
Mark 1
,
Mark 2
and
Mark 3
in order. Three marking points will be
recorded.
Tip: For how many marking points you need to take, see Should I use
two templates or three templates?
Tip: It is recommended to take marking points at specified shooting
positions on workpiece that will be machined next.
3.
Click
Show Box
, and select templates of different size by dragging the mouse.
Make sure characteristic of the template is obvious enough.
WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
- 17 -
