Operating Manual
Digital Multifunctional
Power Meter
with LED Display
- 3 -
679.B.101.03
Membrane key functions
Select digit (lit decimal point)
Increase rating or select menu
Enter menu or accept changes
Enter or leave device settings
Note:
The device will react when releasing a button.
Reading out measured ratings
All measured ratings will be displayed for approximately 10 seconds one after the other.
To read out a particular measured rating, press the
key (repeatedly, if required).
The selected measured rating will then be displayed for approximately 10 seconds. After
that, the next measured rating in the order will be displayed.
Device Settings
On the device, the CT ratio can be set and the energy counters can be reset. For this
purpose the password must be entered.
In the meter settings, also data are shown which cannot be changed or which are not used:
PASS 00
Password
adjustable (see below)
nET 4Y
3-phase 4-wire system
not adjustable
PT 0001
Voltage transformer ratio
not adjustable
CT 0001
Current transformer ratio
adjustable (see below)
Adr 001
Address
not used
bAUd 9600
Baud rate
not used
CLEr no
Reset energy conters
adjustable (see below)
Entering the password (PIN)
The factory-set PIN is:
01
Enter device settings
Select the
PASS
menu
Select digit (lit decimal point)
Adjust value
Adjust second digit in the same way, if necessary.
Confirm
