Weidmüller 1477030000, Original Operating Instructions

Page: 33 / 292

33 2549630000/00/09.2017
Setting up the machine
5.2 Changing the wire-end ferrule reel
► Turn the lock on the front plate to open it.
► Swing the front plate downwards.
► Press the transport bolt fully upwards, and pull the wire-
end ferrule belt out of the transport unit.
► See section 5.2.
5.3 Setting the stripping length (only RS)
A letter is assigned to each wire-end ferrule:
16 mm = A 14 mm = B
► Check whether the applicable letter (A or B) is set to the
following four components:
1. Ferrule stop (Figure 3.2, 4 )
2. Release device (Figure 3.2, 8 )
3. Stranded wire fixing unit (Figure 3.2, 11 )
4. Opening wedge (Figure 3.2, 1 )
Configuring the ferrule stop
Figure 5.1 Ferrule stop configuration
► Turn the adjusting wheel with the hex key (5 mm) so that
the required value is visible.
Two dashes=A, one dash =B.
Adjusting the stripping length on the release device
Figure 5.2 Release device adjustment (set: B)
You can vary the stripping length using the setting.
► Press the adjusting wheel backwards and turn it so that
the required value is at the marked position.
► Release the adjusting wheel so that it latches in.
You can perform fine adjustments within the selected con -
figuration range (A or B):
► To increase the stripping length, turn toward "+"; to re-
duce the stripping length, turn toward "–".
Configuring the stranded wire fixing unit
Figure 5.3 Stranded wire fixing unit configuration (set: B)
► Pull the tool unit forwards and set the lever to the re-
quired value.