Weidmüller 1243790000, Original Operating Instructions

Page: 38 / 342

2518100000/03/06.2017 38
6 Operating the machine
6.1 Normal operation
► Fill the vibrating conveyor bowl with ferrules (max.
2,000 pieces).
► Things to check prior to each activation:
– Is the power cable in a fault-free condition?
– Is the required operating pressure of
5.5 bar present?
– Is the front plate closed?
► Switch on the machine.
The valves audibly start up and a reference run is execut-
ed. The touch display shows readiness for operation.
The ferrules are conveyed to the ferrule feed rail at the in-
side of the vibrating conveyor bowl.
You can accelerate this process by briefly in -
creasing the output of the vibrating conveyor
(see operating menu 2, section 6.5).
6.2 Inserting the wire
Only process wires that are cut cleanly.
All stranded wire must finish with the insulation,
no stranded wire may be shortened or protrude.
Ensure that the end of the wire is inserted even-
ly.
LZ : Ensure that both wire ends are inserted flush.
40 mm
LZ:
Figure 6.1 Insert the wire correctly
► Insert a ( LZ : two) wire(s) into the insertion funnel.
The material is drawn in slightly and processed automati-
cally. Valve noises are audible during this process.
► Once the processing is complete (no more noises), pull
the processed wire(s) out.
6.3 Touch display and operating menus
The touch display indicates the current operating condition.
The lower part of the display is touch-sensitive. You can
navigate through the program using the four control but-
tons.
Figure 6.2 Touch display; display following activation
Button Functions
 Select menu (move forwards) or increase value
 Select menu (move backwards) or reduce value
C
Exit menu (back to menu 1)
E
Activate selected menu or set value
► To select an operating menu, press the arrow keys .
► To switch to the selected menu, press E .
► Move to the desired point inside a menu using the arrow
keys
.
► To activate a selected point, press
E
.
► To exit the menu, press
C
.
Only menus 1 to 3 and 10 are relevant for operation. Here
you can:
Menu 1: Reset the day's piece quantity
Menu 2: Modify the vibrating conveyor output
Menu 3: Change operating mode (standard: crimping and
stripping)
Menu 10: Set language
The remaining menus are only intended for servicing.