Weidmuller Printjet, Operating Instructions Manual, Page: 11 / 42

11
11
+
In the MultiCard frame you see your selected Cards with a double
click you could open it.
Label this with the letter X (see example below) and print out the
markers.
The MultiCards illustrated below show possible printing results as
produced by the PrintJet.
Compare the MultiCard with this illustration. If the type face displa-
ced, you must adjust it to your system. Calculate the difference and
change the figures margin.
File > Plot > settings
A: Measure the deviation and increase the margin setting Vertical .
B: Measure the deviation and decrease the margin setting Vertical .
C: Measure the deviation and increase the margin setting Horizontal .
D: Measure the deviation and decrease the margin setting Horizontal .
Locking clip
Hinges
Marker
Project field
Side sprue
6. Ink cartridges
The ink cartridges are sealed units. No ink leaks from the
cartridge under normal conditions.
If you get ink on your skin, clean thoroughly with soap and
water. If you get ink in your eyes, immediately rinse thoroug-
hly with water.
Inserting an ink cartridge
1. Press the Replace ink cartridge button.
2. The print head travels to the middle automatically.
Never move the print head manually.
3. Press the locking clip on the ink cartridge to be replaced and
fold back the clip out of the way.
4. Remove the label on which "Remove” is printed.
5. Insert the cartridge (with the label on top and the chip facing
the input rail) onto the hinges.
6. Carefully press the locking clip down until this clicks into
position.
7. Close the cover of the printer.
8. Press the Replace ink cartridge button.
The ink feed system has now been activated and this process takes
approx. 1-2 minutes. Afterwards, the print head returns to the start
position (on the far right) and the green operating LED remains on.
Never switch off the printer while the green LED is flashing.
MultiCards
You can use half-size MultiCards only when these are separated cor-
rectly at the project field.
Place the MultiCard with the project field in the direction of feeding
on the input rail. In doing so, make sure that the MultiCard is pus-
hed in right up to the stop.
Please proof the resistant of the ink regular.
The marking were print on
the Project Field.
B A
- +
+
The marking were print at
the and of the MultiCard.
The marking were print
beside the MultiCard.
The marking were print be-
side the MultiCard.
-
D C
-
+
-
+
X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X X
X
X
X
X
X
X
X