IE-CS(T)-2TX-xRS232/485
Web Console Configuration
5-23
UDP Mode
Packing length
Setting
Factory Default
Necessity
0 to 1024
0
Optional
Default = 0, The Delimiter Process will be followed, regardless of the length of the data packet. If the data
length (in bytes) matches the configured value, the data will be forced out. The data length can be configured
for 0 to 1024 bytes. Set to 0 if you do not need to limit the length.
Delimiter 1
Setting
Factory Default
Necessity
00 to FF
None
Optional
Delimiter 2
Setting
Factory Default
Necessity
00 to FF
None
Optional
Once the IE-CS(T)-2TX-xRS232/485 receives both delimiters through its serial port, it immediately packs all
data currently in its buffer and sends it out the IE-CS(T)-2TX-xRS232/485’s Ethernet port.
ATTENTION
Delimiter 2 is optional. If left blank, then Delimiter 1 alone trips clearing of the buffer. If the size of the serial
data received is greater than 1 KB, the IE-CS(T)-2TX-xRS232/485 will automatically pack the data and send
it to the Ethernet. However, to use the delimiter function, you must at least enable Delimiter 1. If Delimiter
1 is left blank and Delimiter 2 is enabled, the delimiter function will not work properly.
Delimiter process
Setting
Factory Default
Necessity
Do Nothing,
Del 1,
Del 2,
Strip Delimiter
Do Nothing
Optional
Del 1
or
Del 2
: The data will be transmitted when an additional byte (for Del1), or
an additional 2 bytes (for Del2) of data is received after receiving the Delimiter.
