Stripping and crimping machine
Crimpfix 2.5 M
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
13
10.3 Striping blades changing position
Figure 8: Striping blades changing position
→
Striping blades changing position
→
Basic position
•
Remove the magazine
•
Unscrew and remove the feeding funnel
•
3x
M.Motor
•
E
5s
Confirm
•
C
Starting position
•
Press until Motor stops.
•
Switch off the machine and unplug it.
•
Remove the stripping waste container
•
Unscrew and remove the reel holder
•
Unscrew and remove the flap
•
Remove the cover. (Screws at the bottom plate
and at the line filter)
•
Remove right, red marked screw (3).
•
Push the shaft (1) to the front and remove it.
•
Loosen the plug connection at the S-Motor (8).
•
Remove the two fixing screws of the key
attachment (10) and take it out to the front with
the key.
•
Turn the stripping slide (7) to the left.
•
Take care that the pin at the bottom side of the
stripping slide (7) snaps into the groove (2) of the
driving lever when it swings back.
•
Push the shaft (1) back and fix it with the right, red
marked screw (3). Take care that the screw (3)
snaps into the groove of the shaft(1).
•
Assembly the cover, the reel holder and the flap.
•
Put the stripping waste container in.
•
Put the machine into operation again.
•
3x
M.Motor
•
E
5s
Confirm
•
C
Start position
•
E
Quit menu and back to main menu.
•
Put in the magazine again.
•
Control the stripping quality.
2
1
3
5
9
1 Shaft
2
Groove – driving lever
3
Right screw, red marked
4 Protection
plate
5
Left screw, red marked
6 Magazine
holder
7 Stripping
slide
8 S-Motor
9 Table
guidance
10
Fixing screw – key
attachment
10
4
8
6
7
