Stripping and crimping machine
Crimpfix 2.5 M
08-09-19-DK-Operating Manual_gb.doc / 2008-09-19
12
9. Special
functions
9.1 Display
Contrast
Mains
Edit
E
Exit
9.2
Adjusting Stripping Depth
Remove the magazine
Close the flap
2x
S-Motor
E
Press it 5 seconds till cursor
starts blinking
Reduce
D
¼
enhance cutting
depth
or
Enhance
D
¼
reduce cutting
depth
E
Confirm and back to the
operating menu
Check the stripping quality after changing the
stripping depth. (Chapter 7.6)
1
3
b
a
=
a
b
D
Isolation
Cutting edge of the stripping blades
Stranded wires
Figure 7: Top view of a correct stripping
The cut edge of the stripping blades have to look like a rue
and must be symmetrical to the stranded wires
Program Cross section
Diameter
Wire type
Wire manufacturer
1 0,34
mm² 1,20
mm LiY
2 0,5
mm² 1,40
mm H05V-K
3 0,75
mm² 1,60
mm H05V-K
4 1,0
mm² 1,80
mm H05V-K
5 1,5
mm² 2,10
mm H07V-K
The adjusted guide values
depend on wire type and wire
manufacturer and can be used
for new intact striping blades.
6 2,5
mm² 2,45
mm H07V-K
LAPPKABEL
10. Maintenance
See chapter 3.8. Using risks
10.1 Stripping-waste
container
•
Regularly empty the stripping-waste container.
10.2 Interior
•
Switch off the machine and unplug it.
•
Remove the stripping-waste and other impurities
•
Do not clean with compressed air.
•
Do not oil and/or lubricate the machine.