23
Make sure that all parts are properly tightened each time the weight system is used. Replace any worn parts
immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use
solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the
weight pin into the middle of the weight stack. Slack can be removed from these cables several ways.
See the inset drawing. Tighten the M8 Locknut (58)
that connects the end of the Low Cable (53) to the
U-bracket (45).
To further tighten the cables, remove the M10 Locknut
(56) and the M10 x 51mm Bolt (66) from the Cable
Trap (51), the 90mm Pulley (48), the two Half Guards
(43), and the U-bracket (45). Reattach the Pulley,
Cable Trap, and Half Guards to the other hole in the
U-bracket. Make sure that the Cable Trap is in the
proper position and that the Low Cable (53) and
Pulley move smoothly.
To further tighten the cables, loosen the M12 Nut (82)
on the High Cable (55). Next, tighten the High Cable
into the Weight Selector (24) until the slack is removed
from the High Cable. Then, retighten the M12 Nut
against the Large Washer (78).
48
45
53
82
78
24
Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight
stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and
reinstall it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this
manual.
55
MAINTENANCE
53
45
58
51
66
43
43
56
Summary of Contents for WESY1938C.0
Page 4: ...4...