Weider Pro Lx7, Manual

Page: 11 / 23

11
14. Insert a 50 x 50mm Square Cap (20) into the top end
of the Lat Tower (47).
Locate the Cable (50). Wrap the end with the ball
around a Pulley (49). Attach the Pulley to the top end
of the Lat Tower (47) with an M10 x 100mm Bolt (12),
an M10 Washer (21) and an M10 Nylon Locknut (37).
Make sure the Cable is between the Pulley and the
welded pin on the Lat Tower.
Wrap the Cable (50) around the other Pulley (49).
Attach the Pulley to the Lat Tower (47) with an M10 x
100mm Bolt (12), a Cable Trap (51), an M10 Washer
(21) and an M10 Nylon Locknut (37).
Make sure the Cable Trap (51) is oriented as
shown and that the Cable (50) runs smoothly over
both Pulleys (49).
15. Slide the Weight Carriage (48) onto the Lat Tower
(47). The Weight Carriage must be oriented as
shown.
Slide the Weight Stop (15) onto the Lat Tower (47).
The Bushing (10) must be facing the Weight
Carriage (48).
Align the holes in the Weight Stop (15) with the indi-
cated holes in the Lat Tower (47). Attach the Weight
Stop to the Lat Tower with an M8 x 72mm Bolt (28)
and an M8 Nylon Locknut (36).
Attach the Cable (50) to the bracket on the Weight
Carriage (48) with an M10 x 19mm Bolt (55) and an
M10 Nylon Locknut (37).
Do not overtighten the Nylon Locknut.
14
15
Align
These
Holes
47
37
21
20
21
37
50
49
49
12
Pin
12
51
50
48
28
37
47
55
36
15
10