10
10. Lubricate an M10 x 72mm Bolt (27). Attach the Leg
Lever (3) to the Front Leg (2) with the Bolt and an
M10 Nylon Locknut (37).
10
11. Press four 19mm Round Caps (23) into the ends of
the two Pad Tubes (17).
Insert a Pad Tube (17) through the holes in the Leg
Lever (3).
Insert the remaining Pad Tube through the holes in
the bracket on the Front Leg (2).
Slide two Foam Pads (18) onto each Pad Tube (17).
11
37
3
18
23
3
17
23
27
2
2
18
Lubricate
13. Press a Bushing (10) into the top and bottom of the
Weight Carriage (48).
Press a 2” Round Cap (25) into each end of the
weight tube on the Weight Carriage (48).
Slide a Plastic Weight Stop (31) onto each end of the
weight tube as far as it will go.
Press a Bushing (10) into the top (note the location of
the hole) of the Weight Stop (15).
13
10
25
10
15
48
10
25
31
31
12. Insert a Weight Rest (9) into one of the holes on each
Upright (6, 7).
Make sure the shaft on the Weight Rest goes
through both sides of the Upright.
12
9
9
7
6
Summary of Contents for Pro Lx7
Page 19: ...19 ...