40
2.
Position the Crossbar (3) between the two
Uprights (4).
Note: Make sure the decal on the
Crossbar is in the position shown.
Attach the
Crossbar to each Upright with four M10 x 95mm
Bolts (34), two Support Plates (21), and four M10
Nylon Locknuts (35).
Do not tighten the Nylon
Locknuts yet.
3.
Attach the Frame (1) to the Crossbar (3) with two
M10 x 95mm Bolts (34) and two M10 Nylon
Locknuts (35).
Do not tighten the Nylon
Locknuts yet.
Press two 8mm Bushings (32) into the indicated
locations on the Frame (1).
Press a 75mm x 50mm Inner Cap (20) into the
Frame (1).
4.
Press two 50mm Square Inner Caps (22) into the
Front Stabilizer (2).
Attach the Front Stabilizer (2) to the Frame (1)
with two M10 x 65mm Bolts (36), two M10
Washers (27), and two M10 Nylon Locknuts (35).
Tighten the M10 Nylon Locknuts (34) used in
steps 1-4.
5.
Press four 20mm x 40mm Inner Caps (43) into
the Backrest Frames (10).
Orient the Backrest
Frames as shown. Note: The indents in the
Backrest Frames must be on top.
Attach the Backrest Bracket (9) to the Backrest
Frames (10) with four M8 x 55mm Carriage Bolts
(40) and four M8 Nylon Locknuts (42).
Do not
tighten the Nylon Locknuts yet.
Attach the Backrest (8) to the Backrest Frames
(10) with four M6 x 50mm Bolts (39) and four M6
Washers (19).
Do not tighten the Bolts yet.The
Backrest must be oriented as shown.
7
2
3
Decal
Holes
21
21
34
4
35
35
34
20
1
3
34
32
32
3
2
36
22
22
27
35
1
4
19
39
10
Indent
43
43
39
9
8
5
19
42
42
35
