7
2.
Insert two M10 x 65mm Carriage Bolts (103) up
through the Base (1).
Place a piece of tape over
the Bolt heads to hold them in place.
Connect
the Upright Base (2) to the Base with the two
Carriage Bolts and two M10 Nylon Locknuts
(112).
Do not tighten these Locknuts yet.
Connect the Upright Base (2) to the Base (1) with
two M10 x 67mm Bolts (111) and two M10 Nylon
Locknuts (112).
Fully tighten these Locknuts.
Set the Mech Frame (124) onto the Base (1)
behind the Upright Base. Handtighten two M10 x
73mm Bolts (137) and two M10 Washers (129)
into the indicated holes in the Base and Mech
Frame.
Note: The Mech Frame will not be
shown in the following drawings for clarity.
Note: One end of the Rope (70) is connected
to the Right Arm Frame (171).
Untie the loose
end of the Rope and route it through the Upright
Base (2).
Make sure the Rope is still between
the 90mm Thin Pulley (88) and Cable Trap (78)
(see the inset drawing), and that the loose end
of the Rope crosses under the connected end
of the Rope.
Insert two M14 x 155mm Bolts (107) through the
Right Arm Frame (171) and the Upright Base (2).
Hand tighten two M14 Nylon Locknuts (127) onto
the Bolts.
3.
Route the loose end of the Rope (70) through the
Left Arm Frame (8) and a Swivel Arm (29). Make
sure the Rope is under the indicated rod in the
Swivel Arm.
Attach the Swivel Arm (29) to the Left Arm Frame
(8) with an M4 x 5mm Self-tapping Screw (176).
Attach a “V”-pulley (93) inside the Swivel Arm
(29) with an M10 x 53mm Button Bolt (140) and
an M10 Nylon Locknut (112).
2
171
107
107
112
127
127
112
111
111
2
70
124
129
137
78
88
70
129
137
1
70
103
29
8
2
93
176
140
112
Rod
169
166
Large
Hole
165
70
4.
Route the loose end of the Rope (70) through a
Rope Cover (169) and a Link (167) as shown.
Make sure the large hole in the Rope Cover is
on the side shown.
Secure the set of Rope
Clamps (165, 166) on the Rope with two M5 x
16mm Button Screws (164).
Make sure that
Rope is in the grooves of the Rope Clamps,
that there is 1/2" between the Link and the
Rope Clamps, and that the two Screws are fully
tightened.
Slide the Rope Cover over the Rope
Clamps.
167
164
4
3
