10
10
129
124
1
137
137
129
144
129
3
14
15
137
10. Insert an M10 x 125mm Button Screw (144)
through an M10 Washer (129), the Upright (3),
and the Backing Plate (not shown).
Hold the Bolt
in place by sticking a piece of tape over the
bolt head.
Tighten the two M10 Nylon Locknuts (112)
used in step 6. Tighten the two M10 x 20mm
Screws (113) and two M10 x 25mm Screws
(105) used in step 9.
Attach the Mech Frame (124) to the Base (1) with
two M10 x 73mm Bolts (137) and two M10
Washers (129).
Do not tighten the Bolts yet.
Attach the Mech Frame (124) to the Upright (3)
with the M10 x 125mm Button Screw (144).
Make
sure the Upright and Mech Frame are properly
aligned before tighten the Screw.
Tighten the four M10 x 73mm Bolts (137) in
the Base (1) and the two M10 Nylon Locknuts
(112) used in the first paragraph of step 2.
173
81
183
196
173
11. Locate the Lower Wire Harness (173) (see the
inset drawing). Connect the Lower Wire Harness
to the Sensor (196).
The connector should slide
easily into the socket and snap into place.
If the
connector does not slide easily and snap into place,
turn the connector over and then insert it.
IF THE
CONNECTOR IS NOT INSERTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Snap the Sensor Plate (183) into the Side Mech
Cover (81).
12. Snap the Side Mech Cover (81) into place on the
Mech Covers (14 and 15).
11
15
14
81
12
