4. Press a 1 1/2” Square Inner Cap (100) into the
indicated part of the Press Upright (6).
Orient the Press Upright (6) as shown. Attach the
Press Upright to the indicated 5/16” x 2 1/2”
Carriage Bolts (54) in the Press Base (3) with two
5/16” Nylon Locknuts (64).
Attach the Support Brace (7) to the indicated 3/8”
x 2 1/2” Carriage Bolts (76) in the Press Base (3)
with two 3/8” Nylon Locknuts (74).
Attach the Support Brace (7) to the Press Upright
(6) with two 5/16” x 2 1/2” Carriage Bolts (54) and
two 5/16” Nylon Locknuts (64).
Do not tighten the Nylon Locknuts (64, 74) yet.
4
7
5. Press two 1” Inner Caps (32) into the ends of the
weight tube on a Weight Carriage (28).
If you will be using Olympic weights with the
weight system, slide a Weight Sleeve (27) onto
each end of the weight tube on the Weight
Carriage (28). Secure each Weight Sleeve with a
Locking Pin (31).
Note: The drawings in this
manual show the Weight Sleeves attached.
The Locking Pins will be found in the bag
labled “SEAT ASSEMBLY”.
Repeat this step with the other Weight Carriage
(28).
5
64
64
64
100
64
74
74
32
31
31
3
54
54
6
7
76
28
Weight Tube
6. Press a Weight Bumper (56) onto each bumper
tube on the Center Base (2). Press a 1 1/2”
Round Inner Cap (67) into each bumper tube.
Attach two Weight Guides (33) to the indicated
tube in the Center Base (2) with a 3/8” x 6” Bolt
(89) and a 3/8” Nylon Locknut (74).
Attach the other set of Weight Guides (33) in the
same manner.
Do not tighten the 3/8” Nylon Locknuts (74)
yet.
6
89
33
33
74
Bumper
Tube
Tube
67
67
56
56
2
27
27
