5
ASSEMBLY
1
58
58
58
55
20
49
40
49
1.
Before beginning assembly, be sure that
you have read and understand the infor-
mation in the box above.
Locate and open the parts bags labeled
“FRAME ASSEMBLY—METAL” and
“FRAME ASSEMBLY—PLASTIC.”
Press three 2” Square Outer Caps (58) onto
the Weight Base (14) in the indicated loca-
tions.
Insert four 5/16” x 2 1/2” Carriage Bolts (49)
up through the Press Base (13). Insert four
5/16” x 2 1/2” Carriage Bolts up through the
Weight Base (14). Insert a 3/8” x 4” Carriage
Bolt (57) up through the Weight Base.
Attach the Press Base (13) to the Weight
Base (14) with two 5/16” x 2 3/4” Bolts (55),
two 5/16” Washers (20) and two 5/16” Nylon
Locknuts (40). Fully tighten the Nylon
Locknuts.
FRAME ASSEMBL
Y
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Assembly is divided into four stages: 1) frame
assembly, 2) press and butterfly arm assembly,
3) cable and pulley assembly and 4) seat and
backrest assembly. The hardware for each stage
is packaged separately.
• Wait until you begin each assembly stage to open
the parts bag labeled for that assembly stage.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART located in the center of this manual.
Note: Some small parts may have been pre-
attached for shipping. If a part is not in the parts
bag, check to see if it has been pre-attached.
• As you assemble this product, be sure that all
parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) phillips screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
13
14
49
57
