9
10. Insert the two Short Pad Tubes (129) into the Leg
Lever (110). Slide two Foam Pads (128) onto
each Short Pad Tube. Then, press a 19mm
Round Cap (140) into each Foam Pad.
Insert the Long Pad Tube (130) into the Front Leg
(109). Slide two Foam Pads (128) onto the Long
Pad Tube. Then, press a 19mm Round Cap (140)
into each Foam Pad.
9.
Grease an M10 x 183mm Bolt (83). Attach the
Backrest Frames (118) and the Seat Frame (122)
to the Bench Frame (107) with the Bolt, two M10
Washers (66), and an M10 Nylon Locknut (65).
Do not overtighten the Nylon Locknut; the
Backrest Frames and the Seat Frame must
pivot easily.
See the inset drawing.
Attach the Seat Pin (123)
to the Seat Frame (122) with an M4 x 15mm Self-
tapping Screw (95). Then, insert the Seat Pin
through the Seat Frame and the Bench Frame
(107).
See step 5. Tighten the M8 Nylon Locknuts (84).
See step 6. Tighten the M6 x 40mm Screws (80).
122
66
107
Grease
66
65
118
83
9
128
129
128
128
128
110
140
140
140
140
129
10
95
123
122
130
109
107
11. Attach the Curl Pad (114) to the Curl Post (113)
with two M6 x 20mm Screws (100).
114
113
100
11
128
