13
18. Attach a Handle (12) to the Left Frame (4) with
two M10 x 80mm Button Bolts (52), two M10
Curved Washers (50), and two M10 Locknuts
(65).
Attach the other Handle (12) in the same
way.
Make sure that all parts are properly tight-
ened before you use the inversion system.
18
65
50
52
12
12
65
4
35
13
65
10
WARNING:
HOW TO LOCK THE INVERSION SYSTEM
FOR STORE DISPLAY OR TO
PREVENT UNSUPERVISED USE
When the inversion system is displayed in a
store, or when it is not in use, it should be
locked to prevent unsupervised use. First,
insert the threaded end of the Lock Pin (35)
into the Support Leg (13), and position the
other end of the Lock Pin on top of the Leg
Frame (10). Then, tighten an M10 Locknut
(65) onto the Lock Pin.
8
6.
See the inset drawing.
Identify the Center
Frame (7).
Apply some of the included grease to both sides
of the Left Large Spacer (31).
Attach the Left Large Spacer (31) and the Left
Frame (4) to the Center Frame (7) with an M10
Locknut (65), an M10 Large Washer (64), and a
29mm Spacer (48). Then, press an 89mm Cap
(32) into the Center Frame.
Repeat this step with the Right Large Spacer
(70) and the Right Frame (5).
7. Attach the Left and Right Frames (4, 5) to the
Left and Right Bases (1, 2) with four M10 x
85mm Button Bolts (51) and four M10 Locknuts
(65).
7
65
51
51
1
2
65
65
65
4
5
32
65
64
48
4
7
31
Grease
70
5
6
7
