Maintenance
71
Change the air filters
Release clamp (2).
Remove air filter (3) and clamp (2)
from flange of intake housing (1).
Verify that there are no objects in
the flange of the intake housing (1)
and clean it.
Place new air filter (3) with clamp
(2) onto intake housing (1).
Tighten clamp (2).
Figure 5.3.1.V
Replace oil filters
Note!
Hot oil and components can cause personal injury. Wear gloves to prevent hot oil or
components from contacting your skin. Do not install the filters over tighten.
Clean the area around the oil filters
and place a proper container under
the oil filters, Remove the used
filters and discard it in a safe place
and in accordance with your local
regulations.
Make sure the gasket from the
used filters does not remain stuck
to the filters head. Wipe the oil
from the filters seat with a cloth.
Figure 5.3.1.W
Apply a thin layer of oil to the
gasket on the new filters.
Tighten the filters by hand until the
gasket
contacts
the
sealing
surface,
then
tighten
it
an
additional ¾~1 turn.
Start the engine and run at idle.
Inspect the filters for any oil leak,
and inspect the oil pressure. If
there is leak, retighten the filters,
clean the leak, and then inspect for
the leak in idle again.
Figure 5.3.1.X
于千钧
“1005098300 - Operation_and_Maintenance_Manual_for_PowerKit_16M33_Series_Gas_Engine, A”
林世龙
许太法
宋安泽
20200425
于千钧
张安勇/Zhang Anyong
王巧荣
